The corresponding adjustment should be made according to the requirements of the slicing. Typically, adjusted in time, should first loosen the fastening nut thickness direction of rotation pillars, the nut and the regulation on the pillars, the thickness adjusting properly, must put the nut and tighten the pillars. If the knife plate is parallel to the blade, do not turn on. The knife plate must be lower than the blade, and the slicer device can be sliced. The thickest adjustment is usually about 3mm, and the thinner is stepless.
After a period of time, or when you need to cut different products, you need to replace the suitable blade. At this time, six angle handles should be used to insert the side hole of the machine. You can adjust the direction of rotation disk change knife, changing the knife blade angle six two loose screw, insert blade replacement. In this way, a slicer can be used to cut thin and uniform tissue slices.
In the process of using the slicer, we need to pay attention to some details. First of all, the cutter basin of slicing machine should often rub oil to avoid scaling. If there is food left behind and fine fragments, it shows that it is soft or not sharp, so it has to be replaced or sharpened. If the tune is too thin, it will also affect the quality of the slicing.
When cutting sticky food with a slicer, it is suggested that the surface be cut with water. In general, the working efficiency of the slicer is high, and the slice thickness can be adjusted, and it is widely used in food processing fields. For the user, the device has the advantages of saving electricity and security.
A very important accessory is the tool holder. In order to achieve different slicing requirements, the tool holder of some devices also has lateral movement, which ensures that the blade length can be fully utilized.
In addition, the locking system and the storage disk are also included. In the frozen meat slicing machine, the hand wheel operated by single hand lock can be easily locked in the upper hand wheel, second wheel lock can be locked in any position of the hand wheel. The storage plate is usually set at the top or side of the equipment to facilitate the use of common tools. Some of the equipment also have a red hand with a red hand, covering the full length of the blade, ensuring safety, protecting the user effectively when slicing and replacing the wax block.
The wonderful content of this article comes from the detailed content of the cutting machine, please click on our official website: http://www.chinafoodjx.com thank you for coming!