欢迎光临济南宏泰食品机械有限公司网站!

全国咨询热线
食品切片机的使用方法
发布时间:2018-06-04 来源:http://www.chinafoodjx.com 发布人:admin

1、调节:调节时先松开固紧铜柱螺母,其次转动螺母与铜柱上的厚薄方向调节,厚薄调妥后,必须把螺母与铜柱拧紧。如果刀盘与刀片平行,切勿开机。刀盘必须低于刀片,才可开机截切。调节更厚约3mm,薄则无级调变。
1, adjust: when adjusting, first loosen the copper nut tightly, then rotate the nut to adjust the thickness of the copper column. After the thickness is adjusted, the nut must be tightened with the copper column. If the knife plate is parallel to the blade, do not turn on. The knife plate must be cut below the blade. The thickest adjustment is about 3mm, and the thinning is stepless.
2、更换刀片:用六角把手插入该机侧面孔位。转动可以调盘方向再换刀,换刀时松掉刀片的二只六角螺丝,插入刀片更换即可。
2, replace the blade: insert the six side handle into the side hole of the machine. Turning can adjust the direction of the disc and then change the knife. When changing the knife, release the two six angle screws of the blade and insert the blade to replace it.
切丁切块机是切制薄而均匀组织片的机械,组织用坚硬的石蜡或其他物质支持,每切一次借切片厚度器自动向前(向刀的方向)推进所需距离,厚度器的梯度通常为1微米。切制石蜡包埋的组织时,由于与前一张切片的蜡边粘着,而制成多张切片的切片条。


The chop cutter is a machine that cuts thin and uniform tissue slices. The tissue is supported by hard paraffin or other material, and the required distance is pushed forward automatically (direction of the knife) by cutting the slice thickness each time. The gradient of the thickness is usually 1 microns. When paraffin embedded tissue is cut, a plurality of slices are made by adhering to the wax edge of the previous section.
切丁切块机使用的注意事项
Cautions for CHICING and cutting machine
1、刀盆常擦油,以免粘垢,如出现食品留尾与细碎片时,这显示软化不妥或刀片不锐利,必须更换或磨刀。调得太薄,尚不好截切。
1, knife basin often rub oil, so as to avoid sticky dirt. If there is food left behind and fine fragments, this shows that the softening is not good or the blade is not sharp, so it must be replaced or sharpened. It is too thin to cut.
2、切片粘性食物,表面带水截切。
2. Sliced sticky food with water cut on the surface.
本机选用单相电机配套,采用高档轴承,并安装四把刀片在刀盘上,速比慢而切片功效高,切片厚薄可以调节,广泛适用于食品加工场等。本机具有体积少、效率高、操作简便、精巧美观,即省电又等特点。
The machine is equipped with a single phase motor, with high grade bearings and four blades on the knife plate. The speed ratio is slow and the slice efficiency is high. The slice thickness can be adjusted, and it is widely used in the food processing field and so on. The machine has the characteristics of small volume, high efficiency, simple operation, exquisite and beautiful appearance, that is, electricity saving and safety.
我们一直以质量,顾客上,作为我们的服务宗旨,我们努力来为您提供满意的服务,我们真诚的欢迎您来本公司视察,选购,希望我们有良好的合作机会,共同创造双赢的局面!
We have been the quality first, customer first, as our service tenet, we strive to provide you with satisfactory service, we sincerely welcome you to this company inspection, selection, hope that we have a good opportunity to cooperate to create a win-win situation together!

上一篇:调整切块机螺杆需要用到的工具
下一篇:洗菜机的使用方法

相关新闻