全国咨询热线
一、操作规程：
1、 Operating procedures:
1、使用前，擦拭机器，面对切片机，先将载物台移更右边，漏出加油口，向其中加5滴油，多次横向载物台，使润滑油均匀分布。
1. Before use, wipe the machine, face the slicer, move the stage to the right, leak out the oil filler, add 5 drops of oil to it, and cross the stage several times to make the lubricating oil evenly distributed.
2、调节切割厚度，先将厚度调更大，再调需要厚度；调好后将夹具打开，放入物料，夹实，并落下重锤。
2. Adjust the cutting thickness, first adjust the thickness to larger, and then adjust to the required thickness; After adjustment, open the clamp, put in the material, clamp it tightly, and drop the heavy hammer.
3、开机检查：检查刀片上是否有异物，检查刀具护板是否盖实，检查磨刀砂轮是否远离刀片。
3. Start up inspection: check whether there is any foreign matter on the blade, whether the tool guard plate is covered tightly, and whether the grinding wheel is far away from the blade.
4、检查无误后，接通电源，打开开关，让其自动运转，操作员不能远离设备，以防发生意外。
4. After checking, turn on the power, turn on the switch and let it run automatically. The operator should not stay away from the equipment to prevent accidents.
5、结束后，先关闭开关，断电，取下废料及半成品，打开刀具护板，将刀片及载物台清理干净（小心刀片锋利）。
5. After finishing, first turn off the switch, turn off the power, remove the waste and semi-finished products, open the tool guard, and clean the blade and loading table (be careful that the blade is sharp).
二、注意事项
2、 Precautions
Two.Precautions
Two.Precautions
1、对手轮进行转动，将标本夹直接升到更高的位置，并转动手轮将手柄停止转动，同时将标本夹和手轮都进行锁定。
1. Rotate the hand wheel to raise the specimen holder to a higher position, turn the hand wheel to stop the handle rotation, and lock both the specimen holder and hand wheel.
2、再从刀架上直接加工切刀片取下，擦拭干净后放置在刀盒内。
2. Then take off the cutting blade from the tool holder, wipe it clean and place it in the tool box.
3、从标本夹上将标本直接的取下。
3. Remove the specimen directly from the specimen holder.
4、对切片机上切片的残屑进行清理。
4. Clean the scraps on the slicer.
5、更后就是对切片机进行整机的清洁。
5. After that is to clean the whole machine.
注意：我们在使用切片刀的时候，一定要格外小心，因为其刀刃非常的锋利，如果误操作的话定会造成严重的伤害，不可以直接的用手去接触切刀片，也不可以将切刀片随意的乱放。
Note: when we use the slicer, we must
