全国咨询热线
切丁机的工作原理：拨盘带动被切物体高速旋转，运用物体离心力，切菜机凭借立刀将被切物体切成片状，然后经过圆盘切丝刀切成条状，全自动肉类切丁机并将被切物料送入横堵截刀口，由横堵截刀切成所需要的立方体或长方体切丁机工作一行程后，料仓存料约一到二毫米，切丁机刀片间隙小于10丝（0.1毫米）。
Working principle of the Dicer: the dial drives the high-speed rotation of the cut object, uses the centrifugal force of the object, the Dicer cuts the cut object into slices with the help of the vertical knife, and then cuts into strips through the disc cutter. The fully automatic meat Dicer will send the cut material to the cross-section knife, and cut the required cube or cuboid Dicer by the cross-section knife after a stroke of operation, the material in the bin will be about One to two millimeters, the cutting machine price blade gap is less than 10 wire (0.1 mm).
运用本机前，请先用温水清洗洁净，全自动肉类切丁机不要弄湿电机。
Before using this machine, please clean it with warm water first. Do not wet the motor of automatic meat cutting machine.
运用肉类切片机时，先开动电机，看刀片转向是否正确。切丁机如果逆转应马上纠正。
When using the meat slicer, first turn on the motor to see if the blade rotation is correct. If the Dicer is reversed, it should be corrected immediately.
用完后，先关掉电源，将可撤除部分拆下，用热水洗洁净，然后装上，开空机甩水份，再涂上食用油即可。
After use, first turn off the power supply, remove the removable part, wash it with hot water, then install it, turn on the empty machine to shake the water, and then apply edible oil.
需切肉丝时，先将肉切成片后，将肉片横向再切一刀即可。
When it is necessary to cut the meat shreds, first cut the meat into slices, then cut the slices horizontally and then one knife.
运用绞肉机时，先将绞肉器用水洗净，再按原样装好，切丁机压紧大压盖后才可运用。待绞的肉块不要太大，不然会被卡住。
When using the meat grinder, first wash the meat grinder with water, then install it as it is, and then use it after the price of the Dicer is pressed on the big gland. The meat to be ground should not be too large, or it will get stuck.
要绞的肉和要切的肉不行有骨，不然会损坏绞刀和切片刀。本机还可用切榨菜、萝卜等无骨、无壳的食品。
The meat to be ground and the meat to be cut must not have bones, or the cutter and slicer will be damaged. The machine can also be used to cut mustard, radish and other boneless, SHELLLESS food.
本机采用了离合器结构，切菜机绞肉机和切片机可分隔运用。不必的绞肉机和切片机可以推动离合器手柄，使它与传动系统别离，即可暂停工作，操作时请勿用手推肉注意（机器开动才能连合，停机后挂空挡才能别离）。
The machine adopts clutch structure, and the meat cutter and slicer can be used separately. The unnecessary meat grinder and slicer can push the clutch handle to separate it from the transmission system, so that the operation can be suspended. Do not push the meat by hand during operation. Pay attention to safety (the machine can be connected only when it is started, and can be separated only when it is in neutral gear after it is stopped).
以上是切丁切块机的使用流程，希望对你们有所帮助，想要了解更多请咨询网站。
The above is the use process of Dicer. I hope it can help you. For more information, please consult the website.
