谈谈关于切片机各个位置的润滑和保养
发布时间：2020-09-07
来源：http://www.chinafoodjx.com
发布人：admin
现在市面上各式各样的机械设备变得越来越多，这其中也不乏一些精度高的机械设备，它们的出现是科技进步的印证，切片机是现在常见的一种设备，在使用它的时候要按时对其进行润滑。
Now there are more and more kinds of machinery and equipment on the market. There are also some high-precision mechanical equipment. Their appearance is the confirmation of scientific and technological progress. Slicer is a common equipment now. When using it, it should be lubricated on time.
切片机中需要润滑的部位有不少，采用的润滑介质也是有区别的，比如说它的离合器、弹簧、链轮张紧装置、往返运动部位导轴、开合机构等部位的润滑加黄油。
There are many parts in the slicer that need to be lubricated, and the lubricating media used are also different. For example, the lubrication of clutch, spring, sprocket tensioning device, guide shaft of reciprocating motion part, opening and closing mechanism, etc.
而切片机中的位块凸轮装置、主传动室润滑要加机油，且半年换1次机油，由视窗油的清澈程度决定；角度分割器润滑每半年1次；空压机润滑，三个月加1次。
The lubricating oil should be added to the position block cam device and main transmission chamber of the slicer, and the oil should be changed every half a year, which is determined by the clarity of the window oil; the angle divider should be lubricated once every half a year; the air compressor should be lubricated once every three months.
除了润滑之外，在使用它的时候，还要留意防尘和清洁、电气方面的故障。除了这些以外，它的换油也是很重要的，要保障平台的四角度与上净平台之间的间隔，只有保持正确的间隔，才能使机器正常的运转。
In addition to lubrication, in the use of it, but also pay attention to dust and cleaning, electrical failure. In addition to these, its oil change is also very important. To ensure the spacing between the four angles of the platform and the upper clean platform, only by maintaining the correct interval can the machine run normally.
在切片机切片时，还要注意不要将大量的废纸边、纸毛弄进链条传动部位、模切部动平台及一些其它的旋转部位，以免造成运转故障，损害切片机，如果在日常使用它的时候不能较好的保养机器，不但会额外的增加维修机器的开支，对机器的损害也很大。
When slicing the slicer, pay attention not to put a lot of waste paper edge and paper wool into the chain drive part, die cutting part moving platform and some other rotating parts, so as to avoid running failure and damage to the slicer. If the machine can not be maintained well in daily use, it will not only increase the cost of repairing the machine, but also cause great damage to the machine.
