全国咨询热线
了解切丝切片机使用方法，可以让您的切片机使用寿命更加长，以下来关注一下切丝切片机的使用方法：
Understanding how to use the slicer can make the life of your slicer longer. Here's how to use the slicer.
1、调节:调节时先松开固紧铜柱螺母,其次转动螺母与铜柱上的厚薄方向调节,厚薄调妥后,必须把螺母与铜柱拧紧。如果刀盘与刀片平行,切勿开机。刀盘必须低于刀片,才可开机截切。调节zui厚约3mm,薄则无级调变。
1. Adjustment: First loosen the fastening nut, then turn the nut to adjust the thickness of the copper column. After the thickness is adjusted, the nut and the copper column must be tightened. If the cutter head is parallel to the blade, do not turn on the machine. The cutter head must be lower than the blade before cutting. The thickness of Zui is about 3 mm, while the thickness of Zui is stepless.
2、更换刀片:用六角把手插入该机侧面孔位。转动可以调盘方向再换刀,换刀时松掉刀片的二只六角螺丝,插入刀片更换即可。
2. Change the blade: Insert the hexagonal handle into the side hole position of the machine. Turning can adjust the direction of the wheel and change the knife. When changing the knife, loosen the two hexagonal screw of the blade and insert the blade for replacement.
切丝切片机是切制薄而均匀组织片的机械，组织用坚硬的石蜡或其他物质支持，每切一次借切片厚度器自动向前(向刀的方向)推进所需距离，厚度器的梯度通常为1微米。切制石蜡包埋的组织时，由于与前一张切片的蜡边粘着，而制成多张切片的切片条。
The slicer is a machine for slicing thin and uniform tissue. The tissue is supported by hard paraffin or other substances. Every time the slice thickness is used to advance automatically (toward the direction of the knife). The gradient of the thickness is usually 1 micron. When paraffin-embedded tissues are cut, slices of multiple slices are made because they adhere to the wax edge of the previous slice.
切丝切片机注意事项
Cautions for slicer
1、刀盆常擦油,以免粘垢,如出现食品留尾与细碎片时,这显示软化不妥或刀片不锐利,必须更换或磨刀。调得太薄,尚不好截切。
1. The knife basin is often oiled to avoid dirt. If there are food tails and fine fragments, this shows that the softening is not appropriate or the blade is not sharp, the knife must be replaced or sharpened. It's too thin to cut.
2、切片粘性食物,表面带水截切。
2. Slice sticky food with water on the surface.
以上就是关于切丝切片机的使用方法与注意事项的介绍，如果您想了解更多关于切丝切片机的新闻资讯，请关注我们http://www.chinafoodjx.com。
The above is an introduction to the usage and precautions of the slicer. If you want to know more about the slicer, please pay attention to us at http://www.chinafoodjx.com.
